Zerkap Tether Tool is Ready!

An accessory to our zerk grease fitting cover Zerkap is the tether which keeps it attached to the base of the fitting. This accessory allows the cover to be removed and safely stored at the point of servicing for immediate re-installation. It is a two cavity mold that cycles in under 20 seconds, allowing a weekly production of approximately 15,000 tethers per shift.

The video shows the tool being tested in a 33T Cincinnati Milacron injection molder. Production to begin January 2020.

Zerkap Tether Tool on 33T Cincinnati Milacron Injection Molder

Zerkap tether tool was setup and test run today. Ready to make parts next week!

Posted by Mainline Manufacturing Company on Tuesday, December 24, 2019
Share this post:

Leave a Reply

Your email address will not be published. Required fields are marked *